SMC Networks SMC TigerStack IV SMC6224M - Manual (Page 394)

C
OMMAND
L
INE
I
NTERFACE
4-146
auto-negotiation is disabled, you must manually specify the link
attributes with the speed-duplex and flowcontrol commands.
• If autonegotiation is disabled, auto-MDI/MDI-X pin signal
configuration will also be disabled for the RJ-45 ports.
Example
The following example configures port 11 to use autonegotiation.
Related Commands
capabilities (4-146)
speed-duplex (4-144)
capabilities
This command advertises the port capabilities of a given interface during
autonegotiation. Use the no form with parameters to remove an advertised
capability, or the no form without parameters to restore the default values.
Syntax
[no] capabilities {1000full | 100full | 100half | 10full | 10half |
flowcontrol | symmetric}
• 1000full - Supports 1000 Mbps full-duplex operation
• 100full - Supports 100 Mbps full-duplex operation
• 100half - Supports 100 Mbps half-duplex operation
• 10full - Supports 10 Mbps full-duplex operation
• 10half - Supports 10 Mbps half-duplex operation
• flowcontrol - Supports flow control
• symmetric (Gigabit only) - When specified, the port transmits and
receives pause frames; when not specified, the port will
auto-negotiate to determine the sender and receiver for
asymmetric pause frames. (The current switch ASIC only supports
symmetric pause frames.)
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#