SMC Networks SMC TigerStack IV SMC6224M - Manual (Page 224)

C
ONFIGURING THE
S
WITCH
3-170
Command Attributes
• Default Priority 11 – The priority that is assigned to untagged frames
received on the specified interface. (Range: 0-7, Default: 0)
• Number of Egress Traffic Classes – The number of queue buffers
provided for each port.
Web – Click Priority, Default Port Priority or Default Trunk Priority.
Modify the default priority for any interface, then click Apply.
Figure 3-72 Port Priority Configuration
CLI – This example assigns a default priority of 5 to port 3.
11. CLI displays this information as “Priority for untagged traffic.”
Console(config)#interface ethernet 1/3 4-143
Console(config-if)#switchport priority default 5 4-222
Console(config-if)#end
Console#show interfaces switchport ethernet 1/3
4-154
Information of Eth 1/3
Broadcast threshold: Disabled
LACP status: Disabled
Ingress rate limit: disable, Level: 30
Egress rate limit: disable, Level: 30
VLAN membership mode: Hybrid
Ingress rule: Enabled
Acceptable frame type: Tagged frames only
Native VLAN: 1
Priority for untagged traffic: 5
GVRP status: Disabled
Allowed VLAN: 1(u),
Forbidden VLAN:
Private-VLAN mode: NONE
Private-VLAN host-association: NONE
Private-VLAN mapping: NONE
Console#