SMC Networks SMC TigerStack IV SMC6224M - Manual (Page 373)

A
CCESS
C
ONTROL
L
IST
C
OMMANDS
4-125
map access-list ip
This command sets the output queue for packets matching an ACL rule.
The specified CoS value is only used to map the matching packet to an
output queue; it is not written to the packet itself. Use the no form to
remove the CoS mapping.
Syntax
[no] map access-list ip acl_name cos cos-value
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• cos-value – CoS value. (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
A packet matching a rule within the specified ACL is mapped to one of
the output queues as shown in the following table. For information on
mapping the CoS values to output queues, see queue cos-map on
page 4-224.
Example
Related Commands
queue cos-map (4-224)
show map access-list ip (4-126)
Table 4-35 Egress Queue Priority Mapping
Queue 0 1 2 3
Priority
1,2 0,3 4,5 6,7
Console(config)#interface ethernet 1/25
Console(config-if)#map access-list ip bill cos 0
Console(config-if)#