SMC Networks SMC TigerStack IV SMC6224M - Manual (Page 455)

VLAN C
OMMANDS
4-207
This section describes commands used to configure private VLANs.
To configure primary/secondary associated groups, follow these steps:
1. Use the private-vlan command to designate one or more community
VLANs and the primary VLAN that will channel traffic outside of the
community groups.
2. Use the private-vlan association command to map the community
VLAN(s) to the primary VLAN.
3. Use the switchport mode private-vlan command to configure ports
as promiscuous (i.e., having access to all ports in the primary VLAN)
or host (i.e., community port).
4. Use the switchport private-vlan host-association command to
assign a port to a secondary VLAN.
Table 4-55 Private VLAN Commands
Command Function Mode Page
Edit Private VLAN Groups
private-vlan
Adds or deletes primary, community, or
isolated VLANs VC 4-208
private-vlan association Associates a community VLAN with a
primary VLAN
VC 4-210
Configure Private VLAN Interfaces
switchport mode
private-vlan
Sets an interface to host mode or
promiscuous mode IC 4-211
switchport private-vlan
host-association Associates an interface with a secondary
VLAN IC 4-212
switchport private-vlan
isolated Associates an interface with an isolated
VLAN IC 4-212
switchport private-vlan
mapping Maps an interface to a primary VLAN IC 4-213
Display Private VLAN Information
show vlan private-vlan Shows private VLAN information
NE,
PE 4-215