Siemens SIMATIC INDUSTRIAL PC PCIL43 - Manual (Page 53)

Expansions and configuration
10.4 Installing disk drives
SIMATIC Rack PC IL 43
Operating Instructions, Edition 09/2005, A5E00432875-01
10-7
Removing the drive carrier module
The driver carrier module consists of a horizontal and vertical driver carrier.
Steps for removing the drive carrier module
1
Loosen the mounting screws of the drive
carrier module.
2 Disconnect the power cable and the
data cable from the installed disk drives.
3 Lift the drive carrier module (1) out of the
device until you can access the cables
of the floppy disk drive. Disconnect
these cables.
4 Remove the drive carrier completely
from the device.