Siemens SIMATIC INDUSTRIAL PC PCIL43 - Manual (Page 34)

Commissioning
7.3 Notes on operation
SIMATIC Rack PC IL 43
7-2
Operating Instructions, Edition 09/2005, A5E00432875-01
Switch off the device
Note
On a Windows platform, always shut down the PC by clicking Start > Close.
Press the on/off button behind the front panel door. The green power LED is switched off.
Disconnect the mains connector to isolate the device from mains.
7.3
7.3
Notes on operation
7.3.1 DVD ROM/CD RW
The DVD-ROM/CD-RW drive is an optional feature. Recording methods supported by the
disk drive: Disc at once, Track at once, Session at once, Packet writing, whereby Disc at
once und Track at once are recommended due to their compatibility to other CD drives.
DVD-ROM, CD-ROM, CD-R and Video CDs can be read.
Burner/DVD player software
To utilize the full functionality of our DVD-ROM/CD-RW drive, you need to install additional
software (burning or DVD player software). This software is included on the CD supplied with
the device. Insert the CD in the drive, run setup and follow the instructions on the screen.
Notice
When first starting the burner software, no data carriers should be inserted in the drive. This
is because data carriers with errors can interrupt the automatic hard drive recognition. The
correct display of the possible burning function will therefore not be given.
Notes on burning optical data carriers
Caution
Danger of data errors when burning optical data carriers
Burning operation is permissible only in an undisturbed environment, i.e. shock and vibration
stress must be avoided. Because of heavy fluctuation in the quality of CD-Rs, data may be
corrupted in a burning session, even if no error message is initially displayed. The written
data can only be verified by comparing these with the source. To be on the safe side, data
should be verified after every burning session.