IBM QMS 4525 - Manual (Page 84)

Duplex Printing
QMS 4525 Print System User's Guide 5-14
Using QMS DOC Commands
Use the following QMS DOC command to select duplex printing:
%%IncludeFeature: duplex ( type)
Your choices for type are on (duplex printing), off (simplex printing),
and tumble (tumble duplex). (See the QMS Crown Document Option
Commands manual for complete information.)
Using VMS Commands
If you are connected to the printer through a DECnet network, you
can use the VMS PRINT command parameter SIDES to select duplex
printing.
The PRINT command syntax for duplex printing is
$ PRINT/PARAM=(SIDES= TYPE) filename
Your choices for TYPE are ONE (simplex printing), TWO (duplex
printing), and TUMBLE (tumble duplex). Replace filename with the
name of your file. (See the VMS Interface for QMS Printers manual for
complete information.)
Using UNIX Commands
If you are connected to the printer through a UNIX host, and you have
QMS UNIX host software installed, you can use the -d or the -t option
to the qpr command to select duplex printing.
The qpr command syntax for duplex printing is
qpr -d filename
The qpr command syntax for tumble duplex printing is
qpr -t filename
Replace filename with the name of your file. (See the QMS UNIX
Host Software manual for complete information about using the qpr
command.)
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500