IBM QMS 4525 - Manual (Page 119)

Control Panel
Status Messages
6-19 Troubleshooting
RESETTING ACCOUNTING
Indicates that the Reset Accounting operation is in progress.
SERVICE CALL 20
Indicates that the buffer speed is out of specification during scan. Contact
QMS National Service. See appendix A, “QMS Customer Support,” for
information on how to get help.
SERVICE CALL 21
Indicates that the buffer did not give the SOP signal in time. Contact QMS
National Service. See appendix A, “QMS Customer Support,” for information
on how to get help.
SERVICE CALL 22
Indicates that the buffer did not give the SOP signal in time. Contact QMS
National Service. See appendix A, “QMS Customer Support,” for information
on how to get help.
SERVICE CALL 24
Indicates that no PAV signal was received after the SOP has been
transmitted. Contact QMS National Service. See appendix A, “QMS
Customer Support,” for information on how to get help.
SERVICE CALL 30
Indicates that the corona did not charge. Contact QMS National Service. See
appendix A, “QMS Customer Support,” for information on how to get help.
SERVICE CALL 40
Indicates that the side framing lamps A and /or B failed. Contact QMS
National Service. See appendix A, “QMS Customer Support,” for information
on how to get help.
SERVICE CALL 41
Indicates that the side framing lamp C failed. Contact QMS National Service.
See appendix A, “QMS Customer Support,” for information on how to get
help.
SERVICE CALL 50
Indicates that both cross framing lamps failed. Contact QMS National
Service. See appendix A, “QMS Customer Support,” for information on how
to get help.
SERVICE CALL 90
Indicates that the TTF temperature is out of specification. Contact QMS
National Service. See appendix A, “QMS Customer Support,” for information
on how to get help.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500