IBM QMS 4525 - Manual (Page 67)

Using the Stapler
4-13 Daily Operations
Using the Stapler
The system administrator sets the default stapling option in the Oper-
ator Control menu to enable or disable stapling. Multiple copies of
print jobs are stapled individually.
Stapling requires the following:
„
Staples must be loaded in the stacker/stapler.
„
The print job must contain at least 2 sheets. Up to 35 sheets can
be stapled and deposited in the upper or stacker output bins.
„
The entire job can be held in the batch tray. The batch tray has a
maximum capacity of 35 sheets, but the actual capacity is deter-
mined by the Bin Capacities option in the Administration/Engine/
Finisher Setup menu.
„
Stapling is enabled from the Administration/Engine/Finisher
Setup menu, an application selection, the QMS DOC staple com-
mand, or a network print command.
Refilling Staples
The optional stacker/stapler uses rolls of 10,000 staples. When a roll
of staples is used up,
CHECK STAPLES
displays in the message window and on the local and remote con-
soles.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500