Mitel 5212 - Manual (Page 54)

36 Mitel ® Model 5212/5224 IP Endpoint User Guide for Inter-Tel ® 5000 Systems
Call
F
eatu
res
System Forwarding
You can use System Forwarding to route calls based on the type of call and the idle or busy
status of your endpoint. You cannot program the System Forward destination. You can only
turn it on or off. Contact your system administrator for more information.
To turn on or turn off System Forwarding:
Dial 354 (on/off). SYSTEM FORWARD ON (or OFF) appears.
Placing Conference Calls
You can place a conference call with up to three internal or external parties (for a total of
four parties, including yourself).
To place a conference call:
1. While on the first call, press the Conf button to place the call on hold. CALL NEXT
PARTY TO CNF appears.
2. Place a call to the next conference party (for external calls, press the Outgoing
button or the Outgoing Call access code [the default code is 8], and then dial the
number).
3. After the party answers, announce the conference, and then press the Conf button
to place the call on hold. If necessary, repeat this step to add the remaining
conference party.
4. Press the Conf button again to start the conference. CNF IN PROGRESS appears.
Adding a Conference Party
You can add a conference party during the conference.
To add a conference party:
1. Press the Conf button. This leaves the conference parties connected.
2. Place a call to the party to be added to the conference, and then announce the
conference. Press the Conf button (twice) to add the party and rejoin the
conference.