Mitel 5212 - Manual (Page 47)

Mitel ® Model 5212/5224 IP Endpoint User Guide for Inter-Tel ® 5000 Systems 29
A
n
swerin
g an
d
Placing
C
alls
To search for a directory name or feature:
1. Press (Directory), and then press one of the following:
• 1 for the IC directory.
• 2 for the Outside directory.
• 3 for the Feature directory.
2. Press the dialpad buttons to enter (up to 20) characters. See the table on page 28
for dialpad button character descriptions.
3. Press (Up) or (Down)to scroll through the entries.
4. Press # while the display shows the entry to dial a number or activate a feature
code.
Using Account Codes
Account codes record information for telephone record reports. You may be required to
enter account codes when placing calls. Contact your system administrator for more
information about using account codes.
There are three types of account codes:
• Standard account codes: Automatically entered into the telephone record report
whenever you place a call.
• Forced account codes: Entered before you can place an outside call.
• Optional account codes: Entered at any time during a call.
To enter an optional account code:
1. While off-hook, press (Special), and then dial 390.
2. Enter the optional account code, and then press #.
To set an account code for all calls placed from your endpoint:
Dial 391 followed by the account code, and then press #. This code is used for all
calls made from your endpoint until it is disabled.
To disable the code:
Dial 391, and then press #. ACCOUNT CODE CLEARED appears.
NOTE
The IC directory may display two similar entries, one without an asterisk
and one with an asterisk. The entry without an asterisk is the primary
extension—the entry with an asterisk is a secondary extension.