Motorola Netopia 3342N User Manual
Page 68
Administrator’s Handbook
68
Restrictions: This setting determines the types of traffic the Gateway accepts from the WAN. Admin Dis-
abled means that Gateway traffic is accepted but administrative commands are ignored. None means that
all traffic is accepted. When PPP is enabled,
Admin Disabled is the default.
DHCP/PPPoE/PPPoA Autosensing:
The pull-down menu allows
you to select an autosens-
ing feature, or to disable it.
Selecting between PPPoE/
DHCP or PPPoE/PPPoA
enables automatic sensing
of your WAN connection
type. If you select
PPPoE/
DHCP, the gateway
attempts to connect using
PPPoE first. If the Gateway
fails to connect after 60 seconds, it switches to DHCP. As soon as it can connect via DHCP, the Gateway
chooses and sets DHCP as its default. Other wise, after attempting to connect via DHCP for 60 seconds,
the Gateway switches back to PPPoE. The Gateway will continue to switch back and for th in this manner
until it successfully connects. Similarly, selecting
PPPoE/PPPoA causes the Gateway to attempt to con-
nect by tr ying these protocols in parallel, and using the first one that is successful. If you choose to disable
the feature, select
Off.
ISP Username: This is the username used to authenticate your Gateway with the Service Provider's net-
work. This value is given to you by your Ser vice Provider.
ISP Password: This is the password used to authenticate your Gateway with the Service Provider's net-
work. This value is given to you by your Ser vice Provider.
Connection Type: The pull-down menu allows you to choose to have either an uninterrupted connection or
an as-needed connection.
•
Always On: This setting provides convenience, but it leaves your network permanently connected to
the Internet.
•
Instant On furnishes almost all the benefits of an Always On connection, but has additional security
benefits:
- Your network cannot be attacked when it is not connected.
- Your network may change address with each connection, making it more difficult to attack.
Timeout: (only appears if Instant-On Connection Type is selected) Specifies the time in seconds before dis-
connect if there is no traffic over the Internet link.