Motorola Netopia 3342N - Manual (Page 47)

47
Configure
Button: Configure
The Configuration options are presented in the order of likelihood you will need to use them. Quickstart is
typically accessed during the hardware installation and initial configuration phase. Often, these settings
should be changed only in accordance with information from your Service Provider. LAN and WAN
settings are available to fine-tune your system.
Advanced provides some special capabilities typically used
for gaming or small office environments, or where LAN-side ser vers are involved.
☛
This button will not be available if you log on as User.
Link: Quickstart
How to Use the Quickstart Page. Quickstar t is normally used immediately after the new hardware
is installed. When you are first configuring your Gateway, Quickstar t appears first.
(Once you have configured your Gateway, logging on displays the Home page. Thereafter, if you need to use
Quickstar t, choose it from the Exper t Mode Configure menu.)
Setup Your Gateway using a PPP Connection.
This example screen is the for a PPP Quickstart configuration. Your gateway authenticates with the Ser-
vice Provider equipment using the ISP Username and Password. These values are given to you by your Ser-
vice Provider.
1. Enter your ISP Username and ISP Password.
2. Click Connect to the Internet .