Motorola Netopia 3342N - Manual (Page 263)

263
set ip ethernet A subnet n address ip_address
Specifies an IP address for the subnet n, when subnet n option is on.
set ip ethernet A subnet n netmask netmask
Specifies the subnet mask for the subnet n, when subnet n option is on.
Default IP Gateway Settings
set ip gateway option { on | off }
Specifies whether the Motorola Netopia® Gateway should send packets to a default Gateway if it does not
know how to reach the destination host.
set ip gateway interface { ip-address | ppp-vccn }
Specifies how the Motorola Netopia® Gateway should route information to the default Gateway. If you
select ip-address, you must enter the IP address of a host on a local or remote network. If you specify
ppp, the Motorola Netopia® unit uses the default gateway being used by the remote PPP peer.
IP-over-PPP Settings. Use the following commands to configure settings for routing IP over a vir tual PPP
inter face.
☛
NOTE:
For a DSL platform you must identify the vir tual PPP inter face [ vccn], a number from 1 to 8.
set ip ip-ppp [ vccn ] option { on | off }
Enables or disables IP routing through the vir tual PPP inter face. By default, IP routing is turned on. If you
turn off IP routing and save the new configuration, the Motorola Netopia® Gateway clears IP routing set-
tings
set ip ip-ppp [ vccn ] address ip_address
Assigns an IP address to the vir tual PPP inter face. If you specify an IP address other than 0.0.0.0, your
Motorola Netopia® Gateway will not negotiate its IP address with the remote peer. If the remote peer does
not accept the IP address specified in the ip_address argument as valid, the link will not come up.
The default value for the ip_address argument is 0.0.0.0, which indicates that the vir tual PPP inter face
will use the IP address assigned to it by the remote peer. Note that the remote peer must be configured to
supply an IP address to your Motorola Netopia® Gateway if you enter 0.0.0.0 for the ip_address argu-
ment.