Motorola Netopia 3342N - Manual (Page 247)

247
Common Commands
set bridge sys-bridge {on | off }
Enables or disables bridging ser vices in the Motorola Netopia® Gateway. You must enable bridging ser-
vices within the Motorola Netopia® Gateway before you can enable bridging for a specific inter face.
set bridge concurrent-bridging-routing {on | off }
Enables or disables Concurrent Bridging/Routing.
set bridge dhcp-filterset " string "
Assigns a filterset named string to the bridge configuration.
☛
NOTE:
A filterset can only be configured for the bridge if the system bridge or concurrent bridging/rout-
ing is enabled.
set bridge ethernet option { on | off }
Enables or disables bridging ser vices for the specified vir tual circuit using Ethernet framing.
set bridge dsl vcc n option { on | off }
Enables or disables bridging ser vices for the specified inter face. Specified inter face must be par t of a VLAN
if bridge is turned
on. Only RFC-1483 Bridged encapsulation is supported currently.
• show log command will show that WAN Bridge is enabled when at least one WAN inter face is bridged.
• show ip interfaces and show bridge interfaces commands will show the inter faces that are not in
bridged mode and that are in bridged modes, respectively.
set bridge table-timeout [ 30 ... 6000 ]
Sets the timeout value for bridging table timeout. Default = 30 secs; range = 30 secs – 6000 secs (.5–100
mins).