Motorola Netopia 3342N - Manual (Page 105)

105
Configuring for Bridge Mode
1. Browse into the Motorola Netopia® Gateway’s web interface.
2. Click on the Configure button in the upper Menu bar.
3. Click on the LAN link.
The LAN page appears.
4.
In the box titled LAN IP Interface (Ethernet
100BT):
Make note of the Ethernet IP Address and subnet mask.
You can use this address to access the router in the future.
5. Click on the Advanced link in the left-hand links
toolbar.
6.
Under the heading of Services, click on the Ether-
net Bridge link.
The Ethernet Bridge page appears.
The appearance of this page varies, depending on your
Gateway’s inter faces.
7.
If available:
a. Check the Enable Bridging on Port selection. (This
may be Always On.)
b. Click Submit .
8.
If you want the Gateway to do both bridging
and routing, check the
Enable Concurrent
Bridging/Routing checkbox.
When this mode is enabled, the Gateway will appear to
be a router, but also bridge traffic from the LAN if it has
a valid LAN-side address.
9. Check the Enable System Bridge checkbox.
The window shrinks.