Motorola Netopia 3342N - Manual (Page 13)

13
CHAPTER 1 Introduction
What’s New in 7.7.4
New in Motorola Netopia® Embedded Software Version 7.7.4 are the following features:
• Internet Group Management Protocol (IGMP) Version 3 suppor t.
See
“IGMP (Internet Group Management Protocol)” on page 100 .
• TR-101 Suppor t:
• Concurrent suppor t for PPPoE and IPoE connections on the WAN.
See
“WAN” on page 67 .
• Multiple LAN IP Subnet suppor t. See “LAN” on page 49 .
• Additional DHCP range suppor t. These ranges are associated with the additional
LAN subnets on a 1-to-1 basis.
• DHCP option filtering suppor t. Allows DHCP option data to be used to determine the
desired DHCP address range. See
“DHCP Option Filtering” on page 252 .
• Suppor t for additional WAN settings to control multicast for warding as well as if
0.0.0.0 is used as the source address for IGMP packets.
See “Advanced:” on page 69 .
• Suppor t for “unnumbered” inter faces. For IP inter faces, this allows the address to be
set to
0 and the DHCP client also to be disabled. See page 71 .
• PPPoE/DHCP Autosensing. See “WAN” on page 67 .
• Wireless Multimedia Mode (WMM) suppor t. See “WiFi Multimedia” on page 62 .
• Firewall: ClearSailing is automatically enabled on all 2200-Series ADSL2+ platforms. (Explicit excep-
tions: bonded and VDSL2, 3341, and 3387WG.) See
“Firewall” on page 142 .
• TR-069 Remote device management is automatically enabled by default for 2200-Series Gateways.
(Explicit exceptions: bonded and VDSL2, 3341, 3387WG). See
“TR-069” on page 322 .
• Voice-over-IP (VoIP) Suppor t using Session Initiation Protocol (SIP) for suppor ted models. See “VoIP” on
page 120 and VoIP CLI “VoIP settings” on page 316 .
• Suppor t of VLAN ID 0 on the Ethernet WAN and suppor t for setting p-bits on a segment/por t basis; inter-
VLAN groups. See
“VLAN” on page 107 and CLI “VLAN Settings” on page 311 .
• Backup IP Gateway Suppor t. See “Backup” on page 133 and CLI “Backup IP Gateway Settings” on
page 323 .
Corresponding commands have been added to the Command Line Inter face (CLI). See “Command Line
Inter face” on page 223 .
• Reset WAN por t and wireless counter and CLI command to display individual Ethernet por t statistics.
See
“reset enet [ all ]” on page 231 and “show enet [ all ]” on page 233 .
• CLI for Motorola Netopia® ATA Remote Management.
See
“Remote ATA Configuration Commands” on page 243 .