MITSUBISHI ELECTRIC DX-TL5716U - Manual (Page 69)

65
Recording
Stopping alarm input
You can stop alarm input manually.
You cannot change the settings on the
screen during recording. To make recording settings while
alarm recording is performed continuously, use this function
to prohibit alarm input temporarily and stop recording.
Step
1 Press the SET UP button on the front panel of
the recorder or left-click the mouse.
or
•
Step
2 Select [Recording setting].
Recording setting
• The screen is displayed.
Step
3 Select [Setting] next to [Manual setting].
Setting
• The screen is displayed.
Step
4 Set [Alarm input].
• When you select [Off], alarm input is prohibited for 5
minutes.
This function is effective to the ALARM IN terminal
on the rear panel, motion detection input, emergency
input and communication port input. Alarm input
prohibition is automatically canceled in 5 minutes.
To cancel the prohibition manually, select [On] and
close the screen.
Manual recording
This section describes the method of normal recording by
manual operation.
Before starting manual recording
Notice
• Use to perform manual recording.
Select [Auto setting] or [Manual setting] to set the
picture quality and FPS for normal recording. (
pages 54 to 58)
Tips
• You can use only for manual recording.
to are for timer
recording only. can be also used for
timer recording.
Use the screen ( pages 66 to 69)
to make settings for timer recording.
Step
1 Press the REC/STOP button.
• The REC/STOP button illuminates and recording
starts.
Step
2 To stop recording, press the REC/STOP button
for 2 seconds or longer.
• The recording stops and the REC/STOP button goes
out.