beautypg.com

Viewing images captured by the cameras, Multiplexer function – MITSUBISHI ELECTRIC DX-TL5716U User Manual

Page 46

background image

42

Multiplexer function

You can display images captured by the connected cameras
on 4-split, 9-split, 10-split, 13-split or 16-split screen. In
addition, you can arrange the positions of the displayed
images on the screen.

Camera number buttons

DIGITAL ZOOM button

SPLIT buttons

Direction buttons

SEQUENCE button

OUTPUT A/B button

Notice

You cannot switch the screen mode to the other single
screen modes or split screen mode while the menu
screen is displayed. To switch the screen mode,
close the menu screen fi rst and then press a camera
number button (1 to 16) or SPLIT button.

Single screen display

A live image captured by one camera is displayed on the
screen.

Step

1 Press a camera number button (1 to 16).

The image from the camera corresponding to the

button you pressed is displayed on the entire screen.

Split screen display

Images captured by multiple cameras are displayed on the
split screen.

Step

1 Press the SPLIT button.

Every time you press the button, the screen mode
changes in the order shown below.

4-split button (

): 4-split a 4-split b 4-split c

4-split d 4-split a ...

9-split button (

): 9-split a 9-split b 9-split a

...

10-split button (

): 10-split a 10-split b 10-split

a ...

13-split button (

): 13-split a 13-split b 13-split

a ...

16-split button (

): 16-split screen

Notice

When the camera images are displayed in the split
screen mode, thin black bars may appear at the top
and bottom or right and left of respective images
depending on the types of the cameras you use. This
symptom tends to occur when the size of the camera
image is smaller than that defined by the display
specifi cations of this recorder.

Tips

To set the camera numbers to be displayed in each
screen mode, use in the
menu. You can set the camera numbers to
be displayed differently for Output A and Output B.
(

Page 110)

Sequential display

Images captured by cameras are displayed and switched at
constant intervals.

Step

1 Press the SEQUENCE button.

The sequential display starts in the currently selected

mode, split or single screen display mode.

Sequential display mode has the following types:

Single screen sequential display
4-split sequential display
9-split sequential display
10-split sequential display
13-split sequential display

Step

2 To cancel the sequential display, press the

SEQUENCE button again.

You can also cancel the sequential display by

displaying other type of split screen or by pressing
a camera number button (1 to 16) for single screen
display.

Notice

Sequential display cannot be used during playback.

Tips

To set the order of images to be displayed and the
switching interval, use in the
menu. (

Page 110)

Viewing images captured by the cameras