Microsoft 2045 - Manual (Page 61)

Advanced Features
49
4
CCCC
Press [Adv. Features].
DDDD
Select [Transfer Req.].
EEEE
Press [Receiving Station].
FFFF
Dial an End Receiver.
Note
❒ You cannot enter End Receiver
numbers directly. The numbers
must be stored in Destination
lists, Speed Dial, or Groups in
the Transfer Station(s). To spec-
ify an End Receiver, use the pro-
cedure described below.
❒ To cancel the Transfer Request,
press [Cancel]. The display re-
turns to that of step
E .
Destination List
A Press [q q q q Quick Dial].
B Enter the number of the Desti-
nation list where the End Re-
ceiver is stored.
F o r e x am p le , t o s e le c t t h e
number stored in Quick Dial 01
of the Transfer Station, enter:
{{{{0}}}} {{{{1}}}}.
Speed Dial
A Press [q q q qp p p p Speed Dial].
B Enter the number of the Speed
Dial code.
F o r ex a m pl e, t o sel ec t t h e
number stored in Speed Dial 12
of the Transfer Station, enter:
{{{{1}}}} {{{{2}}}}.
Group Dial
A Press [q q q qp p p pp p p p Group Dial].
B Enter the number of the Group
number.
F o r ex a m pl e, t o sel ec t t h e
number stored in Group Dial 04
of the Transfer Station, enter:
{{{{0}}}} {{{{4}}}}.
GGGG
To specify another End Receiver,
press [Add].
Note
❒ Press [U U U U Prev.] or [T T T T Next] to see
the End Receivers already en-
tered. You can select an End Re-
ceiver from this list and remove
it by pressing [Clear] or the
{{{{Clear/Stop}}}} key.
HHHH
When you have specified all the
End Receivers, press [OK].
IIII
Press [Exit].
The Transfer Stations and End Re-
ceivers are displayed.
JJJJ
Press the
{{{{Start}}}} key.