Motorola 326X V.34 User Manual
Page 130
A-8 Configuration Quick Reference
Configur
ation
Q
uick-Ref
e
re
nce
ATIn
—
Display Software Information (n= 0, 1, 2, 9)
0=displays 960
1=displays 000
2=displays OK
9=displays reason for last disconnect
These messages are sent with OK, when AT command processing is complete.
ATL0/ATL1
Volume
=Soft
Speaker Volume
The speaker volume is set to soft.
ATL2
=Medium
The speaker volume is set to medium.
ATL3
=Loud
The speaker volume is set to loud.
ATM0
Speaker
=Off
Speaker Control
The speaker is always off.
ATM1
=Dialing
The speaker is on when dialing and training, and off when the modem enters data mode.
ATM2
=On
The speaker is always on.
ATM3
=Security
The speaker is on when dialing is complete and off when the modem enters data mode.
ATO0
—
Retrain
The modem leaves command mode and returns online (to data mode).
ATO1
TEST=Retrain
The modem leaves command mode, returns online, and initiates a retrain with the remote
modem.
ATP
Dial
=Pulse
Dial Type
The modem uses pulse dialing unless otherwise specified by the T or P modifiers.
ATQ0
RsltCode
=Enable
Result Codes
Result codes are displayed at the DTE.
ATQ1
=Disable
Result codes are not displayed at the DTE.
ATQ2
=Orig
Result codes are output to the DTE only when operating as an originate modem.
ATS
S-Regxxx
=nnn
S-Register
Lets you view and set S-Registers (where xxx equals the S-Register to change and nnn equals
the value of the register). The value must be within the specified range (see Chapter 5 for a full
description of S-Registers).
ATT
Dial
=Tone
Dial Type
The modem uses tone dialing unless otherwise specified by the T or P modifiers.
ATV0
RsltForm
=Numeric
Result Code Format
Result codes are sent to your DTE as numbers (short form).
ATV1
=Verbose
Result codes are sent to your DTE as full words (long form).
Call Progress
Call Progress
Determines whether the modem waits for call progress signals or blind dials when establishing
calls.
ATX0
=0
The modem uses only NO CARRIER and CONNECT result codes.
ATX1
=1
The modem uses only NO CARRIER, CONNECT, and CONNECT
Table A-1.
AT Commands, Cross-Referenced to Front Panel Options (Continued)
AT
Command
Parameter &
Option
Description
Gray shading indicates country-specific options. See Appendix C for your country’s options.