Monarch Instrument 9402 - Manual (Page 27)

•
If the data is too far to the left on the supply, increase
the number.
•
If the data is too far to the right on the supply, decrease
the number.
The maximum width of the print area is two inches. When you
move the image to the right or left on the supply, avoid moving
the image outside the two-inch print area.
•
As you move the format to the right, fields that move
past the two-inch location of the supply "wrap around"
and appear on the left side. Other fields move the full
length you specify. If your supply is less than two
inches, fields might move off the supply and not print.
•
As you move the format to the left, it stops at the 0.0"
location of the supply. Other fields move the full length
you specify. This can change the relative position of the
fields.
NOTE: Make sure Re-Image All is set to Yes when changing
this setting. See the section in Chapter 6, "Re-Image
All".
To change the setting, follow steps 1 through 3 at the
beginning of this chapter. Then follow the steps below.
1. Press
2
until you see
SUPPLY
< Margin Pos
2. Press
6
. The previous setting appears, for example
Enter margin pos
[+/-99]: +0
S
e
tt
ing
S
upp
ly
Opt
io
n
s
3. Setting Supply Options
3-9