Monarch Instrument 9402 - Manual (Page 25)

Supply Position
This function adjusts how much supply feeds out of the exit
chute. You may need to adjust the supply in or out to allow
•
tags and labels to be torn off.
•
die cut labels to be removed easily, or to prevent them
from falling off.
NOTE: When you adjust the supply position, you need to
check and possibly adjust the print position.
The range is from -99 to +99, and the default is 0. The
adjustments are in dots (0.0052 inch).
•
Increase the number to feed more supply out of the
chute.
•
Decrease the number to feed less supply out of the
chute.
NOTE: Make sure Re-Image All is set to Yes when changing
this setting. See the section in Chapter 6, "Re-Image
All."
To change the setting, follow steps 1 through 3 at the
beginning of this chapter. Then follow the steps below.
1. Press
2
until you see
SUPPLY
< Supply Pos >
2. Press
6
. The previous setting appears, for example
Enter supply pos
[+/-99]: +0
S
e
tt
ing
S
upp
ly
Opt
io
n
s
3. Setting Supply Options
3-7