Matrox Electronic Systems 4SIGHT-M - Manual (Page 46)

46 Chapter 3: Adding devices to the Matrox 4Sight-M motherboard
Connecting a PC/104-Plus board
You can connect up to three PC/104-Plus boards on the Matrox 4Sight-M
motherboard, in a stack-through configuration, as shown below. Each board must
be attached to the other through four jack screws.
Some considerations
The following points are critical when connecting additional PC/104-Plus boards
to the Matrox 4Sight-M motherboard:
• The voltage I/O pins on the Matrox 4Sight-M PC/104-Plus connectors are set to
3.3 V.
Warning • Matrox 4Sight-M cannot tolerate all PC/104-Plus connections. Use only
PC/104-Plus with 3.3 V signalling.
• Matrox 4Sight-M does not support PC/104 ISA boards.
PC/104- board
Plus
module 1
PC/104-
(PCI) connector
Plus
Matrox 4Sight-M motherboard
PC/104- board Plus
PC/104- board
Plus
module 2
module 3
Connect jack-screws
together.
Fit jack-screws inside
appropriate holes.
Top-most board fitted
with top-screws
MATROX IMAGING est distribué par TECHWAY - www.techway.fr - [email protected] - +33 (0)1 64 86 58 30