MicroBoards Technology HCL-6000 - Manual (Page 39)

MICROBOARDS TECHNOLOGY, LLC HCL Series
39
Specifications
DVD Recorder Drive: DVD-+R/RW/DL CD-R/RW Recorder
Power Source: 90V/240V 50-60Hz switchable power supply
Power supply: 400W
Environment: Temperature: 40
°C (104°F) / 5°C (41°F)
Humidity: 20% - 80%
Actual Size (8-drive) Packaged Size (8-drive)
W 20"xD 26"xH 29" W 25"xD 29"xH 34"
(51x66x73.5cm) (63.5x73.5x86.5cm)
100 lbs (45.5 kg) 115 lbs (52.3 kg)
Supported Formats
CD
CD-ROM Mode 1, CD-ROM XA Mode 2 (form 1, form 2),
Photo CD, CD-DA (Audio CD), CD-Extra, CD-R, CD-RW
Recording format
DVD DVD-ROM, DVD-+R/RW/DL, DVD-VIDEO
CD 700MB
Recording capacity
(nominal)
DVD
4.7GB for General DVD
8.3GB for Dual Layer
CD CD-R, CD-RW
Applicable media
DVD DVD-+R, DVD-+RW, DVD-+R DL
Technical Support
For technical questions or support issues, contact Microboards Technology technical support:
United States
PH: 952-556-1639
FAX: 952-556-1628
[email protected]
www.microboards.com
Europe
PH: +44 (0) 845 230 7800
www.microboards.co.uk
Japan
PH: 03-3561-2266
www.microboards.co.jp
Please have the Model and Serial Number of your Microboards Product available when contacting
Technical Support.
Any unauthorized modification to this equipment may result in the revocation by the FCC of the user’s authority to
operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and antenna
•
Connect the equipment into an outlet on a circuit different than that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
This product is in conformity with the EMC Directive (89/336/EEC) through compliance with the following European standards: EN 55022,
EN 55024. The CE mark has been affixed in accordance with the CE Marking Directive 93/68/EEC.
Canadian Department of Communications (DOC) Statement
This Class B digital apparatus complies with the Canadian ICES-003 Issue 4:2004. Cet appareil numerique de la classe B est conforme a la
norme NMB-003 du Canade.