MicroBoards Technology HCL-6000 - Manual (Page 32)

• Operation 32
Loader Utilities
4. Z form Maneuver
Loader Utilities
5.Alignment Protection
Microboards B.30
14.Manage Accounts
Enter PWD
[ ] OK?
Manage Accounts
1. View User
View User
1. [ADMIN ]
13.4 Z form Maneuver
Some drives have bezels that extend out from the front of the drive face. This can cause the disc to catch on
the edge of the bezel of a higher drive as it is being lowered into one of the below drives. Enabling the Z form
Maneuver will allow the robotic arm to lower the disc off center from the front of the drives to clear any
protruding obstacles like the bezels, and then center the disc directly above the extended writer tray just
before the disc is loaded.
To enable the Z form Maneuver function:
Use the Up or Down button to select the Z form Maneuver menu and
press the OK button to enter that menu.
Use the Up or Down button to select whether the Z form Maneuver is on or off, and press the OK
button to select that option.
13.5 Alignment Protection
Enabling Alignment Protection causes each drive tray to quickly slide in and out after a disc has been loaded
into it. This ensures that the disc is set properly in the disc indentation in the tray by “shaking” the disc into
place.
For example, if the disc is not placed squarely in the center as it should be, but rather slightly off the lip, the
“shake” will cause the disc to slide into position in the center of the tray.
Use the Up or Down button to select the Alignment Protection
menu and press the OK button to enter that menu.
Use the Up or Down button to select whether Alignment Protection is on or off, and press the OK
button to select that option.
14. Manage Accounts
This feature allows the administrator to:
¾ Create user accounts and passwords to prevent unauthorized use of this autoloader.
¾ Edit existing user account information, including name and password.
¾ Delete
existing user account(s).
For complete information on Manage Accounts, see Introduction to Manage Accounts on page 11.
To access the Manage Accounts feature, you need to perform the following tasks:
Use the Up or Down button to select the Manage Accounts menu
and press the OK button to enter that menu. You will be shown the
Enter Password menu.
The system will ask you for the Administrator's Password.
The default Administrator's Password is “0000.” To enter, press the Up or Down button to select the first
digit of your password and press the OK button to submit the current digit. You will automatically move to
the next digit. Repeat these steps until you've selected all four digits for your password. After you have
entered the password, press the OK button to “OK” the submission of your password.
Once your password is validated, you will be guided to the main Manage Accounts screen:
The submenus of Manage Accounts are discussed in the sections that follow.
14.1 View User
This menu allows you to view current existing user accounts.
Note: User “Admin” is the administrative account. It will always be there.
Press the OK button to enter this menu
Use the Up or Down button to scroll through the list of users. Press
the ESC button to go back to the Manage Accounts menu.