MicroBoards Technology HCL-6000 - Manual (Page 24)

• Operation 24
Hard Drive Setup
7. Format Hard Drive
Format Hard Drive
Press OK to Continue
Setup
1. Language
Language:
English
Language:
Espanol
Setup
2. Read Error Skip
10.7 Format Hard Drive
This function formats the Hard Drive. It deletes all disc images and re-initiates the Hard Drive. To format the
Hard Drive, use the Up or Down button to navigate to the 7. Format Hard Drive menu:
Press the OK button to enter the Format Hard Drive menu.
Press the OK button to format the Hard Drive. After the Hard Drive has
been formatted, the system will return you to the Format Hard Drive menu.
11. Setup
The 11.Setup menu options are used to configure various options on the autoloader. The Setup menu
consists of the following sub-menus:
¾ Language
¾ Read Error Skip
¾ CD Writing Mode
¾ Max Audio, VCD & CDG Speed
¾ Buzzer
¾ Startup Menu
¾ Screen Saver
¾ Counter
¾ AUTOCOPY Enabled
¾ DVD+R Compatibility Mode
¾ Disable
Drives
Each of these options is discussed in its own subsection.
11.1 Language
This setting allows you to choose the language that you prefer to use when navigating the autoloader. The
autoloader supports multiple languages.
Use the Up or Down button to select the Language menu and press
the OK button to enter that menu.
Use the Up or Down button to select between the languages and press
the OK button to select that option.
11.2 Read Error Skip
Normally, when the autoloader encounters a read error while reading your master disc, the duplication is
aborted and all the recordable media in the writers are ruined. However, if you believe that your master disc
has a small, insignificant error due to physical damage, you can enable this setting to allow the autoloader to
skip any read errors it encounters.
Note: This function does not fix the error; it only skips it to make the rest of the data readable.
Use the Up or Down button to select the Read Error Skip menu and
press the OK button to enter that menu.
Use the Up or Down button to select whether Read Error Skip is on or off, and press the OK button to
select that option.