beautypg.com

Front panel indicators – MITSUBISHI ELECTRIC WD-65736 User Manual

Page 8

background image

8

1. Television Overview

Front-Panel Indicators

LAMP Indicator

LED Color TV Condition

Additional Information

None

Normal TV on or standby condition.

Normal operation.

Green

TV just powered off and lamp is
cooling.

Starts to blink 60 seconds after turning off TV. TV can be turned
back on before blinking starts or after blinking stops, but not
while the indicator is blinking. Normal operation.

Yellow

1. Lamp access door is open or

not secure.

TV will not operate until lamp access door is secure. See
Appendix E for installation information.

2. No lamp installed.

TV will not operate without a lamp. See Appendix E for installa-
tion information.

Red

Lamp no longer illuminates and has
reached the end of the lamp life.

Replace the lamp. The TV will not operate when the lamp no
longer illuminates. See Appendix E for installation information.

Off

Steady On

Slow Blinking

Fast Blinking

STATUS Indicator

LED Color

TV Condition

Additional Information

None

Normal TV on or standby condition.

Normal operation.

Yellow

TV is too hot.

The TV will display a warning message and shut off if it overheats.

t "NCJFOUSPPNUFNQFSBUVSFNBZCFUPPIJHI5VSOPGGUIF57

and let the room temperature to drop.

t $MFBSCMPDLFEBJSWFOUT&OTVSFBUMFBTUBGPVSJODIDMFBS-

ance on all sides of the TV.

t $MFBOUIFMBNQDBSUSJEHFBJSGJMUFS4FF"QQFOEJY&

Red

TV may require service.

Turn off the TV and unplug the set from the AC power source.
Wait one minute and then plug the set back in. See Appendix D.

If the LED is still on, contact your dealer or a Mitsubishi Autho-
rized Service Center. Go to www.mitsubishi-tv.com or call
1-800-332-2119 to receive Authorized Service Center information.

POWER/TIMER Indicator

LED Color

TV Condition

Additional Information

None

TV is powered off.

Normal operation.

Green

TV is powered on.

Normal operation.

Green

TV powered off, auto-on timer is set. Normal operation. TV can be turned on at any time.

Green

TV just plugged into AC outlet.

t

Wait approximately two minutes for blinking to stop before
turning on. Normal operation.

AC just restored after power failure.

t

TV is rebooting after System

t

Reset used.

TV is rebooting after power

t

fluctuation or receiving abnor-
mal digital signals from a digital
channel or digital device.

You have begun the procedure

t

to update software from an
authorized flash memory device.

This manual is related to the following products: