MITSUBISHI ELECTRIC WD-65736 - Manual (Page 13)

2. TV Setup 13
Select a menu language in the Setup menu.
Memorizing Channels
For ANT 1 and ANT 2
To start channel memorization
With the 1. Setup menu displayed, press to high-
light the Scan icon.
Start channel memorization from the Setup menu.
Press 2. to highlight an input selection based on
your connections:
Input Condition
Ant 1 Air
Ant 2 Air When connected to an indoor or
outdoor antenna
Ant 1 Cable
Ant 2 Cable When connected to direct cable (no
cable box)
Press 3. to highlight the on-screen START button.
Press 4. ENTER to start automatic channel memoriza-
tion.
To stop channel memorization before
completion, press CANCEL.
When memorization is complete you can: 5.
t 1SFTTMENU once to return to the top row of icons.
t 1SFTTMENU again to return to the Main menu.
t 1SFTTEXIT to watch TV.
After channels have been memorized:
t To tune to memorized channels, press CH /
while watching TV on the ANT 1 or ANT 2 inputs.
t 6TFUIFSetup > Edit menu (page 43) for additional
channel options, such as adding or deleting chan-
Initial TV Setup, continued nels from memory, naming channels, and saving
favorite channels in custom memory banks.
See chapter 5, “TV Menu Settings,” to:
t 4FUUIF57DMPDL QBHF
t 4FUUIF575JNFS QBHF
t 4FMFDUBO&OFSHZ.PEFUPNBOBHFQPXFSVTFXIJMF
the TV is off (page 46)
t 4FMFDUBMBNQCSJHIUOFTTNPEF QBHF
t &OBCMF%WJEFP QBHFTBOE
Setting Up TV Inputs
When You First Connect a Device
The TV’s Easy Connect™ Auto Input Sensing feature
detects most connections automatically.
Note: For connection and setup of a personal com-
puter, see the information on page 16.
Auto Input Sensing for Most Devices
When you first connect a device, the TV will:
a. Detect the connected device and automatically
switch to it
b. Prompt you to identify the device type
c. Prompt you to perform NetCommand set-up for
the device, if available (736 and 835 series only)
d. Repeat these steps for any additional newly
detected devices
See below for connections which trigger Auto Input Sensing.
Auto Input Sensing Available
VIDEO (detected as composite video)
Y plus Pb (detected as component video)
S-VIDEO
HDMI *
USB (USB photo port on front)
Auto Output Sensing Available
DIGITAL AUDIO OUTPUT
AVR AUDIO OUTPUT red jack
No Auto Sensing
ANT 1 and ANT 2
*
If the device is powered off when connected, detec-
tion occurs when the device is next powered on.
Auto Input Sensing for CEC Devices
Most devices with CEC capabilities enabled are recog-
nized and identified automatically by the TV. This TV’s
NetCommand for HDMI feature (available on all models)
may allow you to control some or all functions of a CEC-
enabled device without further setup. See “NetCommand
for HDMI Devices,” page 28 and check the device’s
owner’s manual for instruction on enabling CEC.