MITSUBISHI ELECTRIC WD-65736 - Manual (Page 51)

51
6 NetCommand IR Control
About NetCommand IR Control
Note: To learn about NetCommand for HDMI devices,
available on all TV models, see “NetCommand
for HDMI Devices” on page 28.
t NetCommand IR home-theater control is avail-
able on the following models:
WD-65736, WD-73736 -
WD-65835, WD-73835 -
t /FU$PNNBOETFUVQJTPQUJPOBM
t :PVNBZXJTIUPVTF/FU$PNNBOE*3DPOUSPMUP
supplement CEC control.
t :PVDBOQFSGPSN/FU$PNNBOETFUVQXIFOUIF57
first recognizes a device during Auto Input Sensing
or at any convenient time afterward.
t /FU$PNNBOEPQFSBUFTCZTFOEJOHSFNPUFDPOUSPM
signals from the TV to your other devices via the IR
emitters, telling the devices to play, record, change
inputs, adjust volume, change channels, or perform
other functions. All this is accomplished with the
TV’s remote control and the slide switch left in the TV
position.
t 5IF*3i-FBSOJOHwGFBUVSFPG/FU$PNNBOEBMMPXT
the TV to learn the IR control signals for your A/V
devices.
t :PVDBODIPPTFUIFMFWFMPG/FU$PNNBOEDPOUSPM
for your home theater.
Standard Setup. Perform a standard setup if
you:
Want NetCommand to control only a few
devices, such as the TV, a playback device
(like a DVD player), and a cable box. With
this setup, you can use the TV’s remote
control to operate these devices.
A/V Receiver Setup. Perform A/V receiver
setup if you want NetCommand to:
Control a surround sound A/V receiver.
Automatically change audio input selections
on an A/V receiver when you change inputs
on the TV.
Automatically change audio and video input
selections on an A/V receiver with an HDMI
output to the TV.
Important Note on NetCommand
Be sure to connect the IR emitter cable to the
TV and properly place the emitters so that
NetCommand can control your devices. See
the explanation on the next page.