MITSUBISHI ELECTRIC WD-65736 - Manual (Page 28)

28 4. TV Operation and Features
ChannelView Channel Listings
ChannelView screen
ChannelView™ shows memorized channels on ANT
1 or ANT 2. It displays channel names and program
information as sent by broadcasters or your local cable
service provider and may be incomplete. No program
information is displayed for analog channels. An analog
channel name is displayed only if you assigned a name
in the Setup > Edit menu (page 43).
To receive ChannelView updates:
Keep the Energy Mode set to t Fast Power On
Set the TV clock t
Leave the TV powered off for a while each day t
to receive updates.
Note: Whenever you watch a digital channel, listings
are updated for the channel you are watching.
Using ChannelView
Feature Press Key
See ChannelView listings
from ANT 1 or ANT 2. Press GUIDE.
Close ChannelView Press GUIDE or EXIT.
Scan channels one by one. Press and hold or .
Scan channels quickly. Press and hold PAGE / .
Jump to listings for a spe-
cific channel. 1. Enter the channel
number (see numbers
in upper left of screen).
2. Press ENTER.
See more of the program
description (if available). Press INFO.
Move navigation to the
program listings. Press .
Move navigation to the
channel listings. Press .
Tune to the highlighted
channel. Press ENTER.
NetCommand for HDMI Devices
Available for all TV models. The TV’s remote may
operate some functions of compatible CEC devices
without any additional setup. See the your devices’
owner’s guides for instructions on enabling the devices’
CEC capabilities.
If you have a CEC-enabled A/V receiver, CEC-enabled
devices connected to the A/V receiver with an HDMI
cable may also be controllable. They can be selected
from the TV’s Input Selection menu. See “A/V
Receiver with HDMI Output,” page 23, and the Inputs >
Name menu, page 47.
Test your equipment with the TV’s remote control to
find out which commands are supported. See below
for commands that may be available, depending on the
individual device.
As an example of using NetCommand for HDMI
devices, you would press PLAY on the device itself to:
Turn on the TV if not already on t
Switch to the device (no need to display the t Input
Selection menu)
Begin play of the device
t
CEC-enabled VCR, DVD, and DVR functions that
may be available:
Record/
Playback
Menu
Navigation
Channel Tuning Other
CH / GUIDE
ENTER Digits 0–9,
—
CANCEL F1 (content) *
—
CANCEL
(to cancel)
ENTER MENU
* The F1 key defaults to work like the devices’s LIST
key.
CEC-enabled A/V receiver functions that may be
available:
Try the t VOL, MUTE, and menu-navigation keys.
To open the A/V receiver menu, follow these steps: t
1. While watching TV, press AUDIO.
2. Press repeatedly until the Speakers option
displays.
3. While Speakers is still displayed, press MENU.
736 and 835 series models: You can add commands
in addition to those supported by CEC. Use NetCom-
mand IR “learning” after connecting and placing IR
emitters for the devices. See “Initial NetCommand
Setup for Most Devices,” page 53, and “Setting Up
NetCommand Control of an A/V Receiver,” page 57.