Gateway ALR 7300 - Manual (Page 29)

Components 19
System jumpers
The jumpers allow you to set certain characteristics of the system. Some
jumpers are reserved and are not described in this section. Do not change
any jumper unless it is necessary to configure the system. In some cases,
changing the settings of reserved jumpers can cause damage to the system
board.
Clear CMOS jumper
This jumper allows you to clear the CMOS memory. You should only do
this if you cannot access the normal methods of modifying the CMOS and
modifications to the CMOS are necessary. Clearing CMOS memory
returns all BIOS Setup settings to the default values.
CPU speed setting jumper
This jumper allows you to set the speed of the processor. Both processors,
in dual processor configurations, must have the same speed rating. If
processors of different speeds are used in the same system, the processors
must run at the speed of the slower processor.
I
2
O feature connector
This connector is designed to accommodate an intelligent input/output
(I
2
O) compatible expansion card. At the time this manual was published, no
fully I
2
O compatible board was available for testing.
Battery
Provides the power to maintain the CMOS memory when the system is
turned off or unplugged.
4075.book Page 19 Friday, April 2, 1999 9:26 AM