GE GEFanuc Automation Programmable Control Products TCP/IP Ethernet Communications for the Series 90t-70 PLC GFK-1004B - Manual (Page 231)

D
TCP/IP Ethernet Communications User’s Manual – January 1996 D-4 GFK-1004B
3Com Etherlink 16
\CONFIG.SYS
FILES=20
BUFFERS=48
DEVICE=\DOS\HIMEM.SYS
DEVICE=\DOS\EMM386.EXE RAM 1024
DOS=HIGH,UMB
DEVICE=\GEFNDIS\PROTMAN.DOS /I:\GEFNDIS
rem
rem The Ethernet Adapter and its device driver must first be installed
rem into your computer. Replace the string “” in the
rem following DEVICEHIGH command with the directory which contains
rem the specified device driver for your Ethernet Adapter module.
rem
DEVICEHIGH=\ELNK16.DOS
DEVICEHIGH=\GEFNDIS\GEFNDIS.DOS
\AUTOEXEC.BAT
SET GSMCFG=C:\GSM\CFILES
rem Bind NDIS Drivers
\GEFNDIS\netbind
\GEFNDIS\PROTOCOL.INI
[protocol manager]
DRIVERNAME = PROTMAN$
[GEFNDIS]
DRIVERNAME = GEFNDIS$
BINDINGS = ELNK16.DOS
MAX_RX_SIZE = 560
NUM_RX_BUFS = 8
; Caution: Interrupt conflicts may arise when using default hardware
; configurations for many Ethernet Adapters. For example,
; interrupt IRQ3 is commonly used for the COM2 serial port
; and most Ethernet adapters.
;
; The following information must match the hardware configuration
; of the Ethernet Adapter as installed on your computer. Please
; modify this information as necessary.
[ELNK16.DOS]
DRIVERNAME = ELNK16$