Login command – GE GEFanuc Automation Programmable Control Products TCP/IP Ethernet Communications for the Series 90t-70 PLC GFK-1004B User Manual
Page 152

5
5-25
GFK-1004B
Chapter 5 The Station Manager
Table 5-9. Log Event Definitions
ББББББ
ББББББ
ББББББ
Log Event
(Hexadecimal)
БББББББББББББББББ
БББББББББББББББББ
БББББББББББББББББ
Cause
ББББББ
ББББББ
1
БББББББББББББББББ
БББББББББББББББББ
Powerup. A log entry of this event will appear every time
the Ethernet Interface is restarted or powered up.
ББББББ
ББББББ
2
БББББББББББББББББ
БББББББББББББББББ
System events.
ББББББ
ББББББ
8
БББББББББББББББББ
БББББББББББББББББ
PLC Driver events.
ББББББ
ББББББ
b
БББББББББББББББББ
БББББББББББББББББ
Service Agent events.
ББББББ
ББББББ
c
БББББББББББББББББ
БББББББББББББББББ
LLC events.
ББББББ
ББББББ
11
БББББББББББББББББ
БББББББББББББББББ
IP Layer events
ББББББ
ББББББ
12
БББББББББББББББББ
БББББББББББББББББ
TCP Layer events
ББББББ
ББББББ
16
БББББББББББББББББ
БББББББББББББББББ
ARP Layer events
ББББББ
ББББББ
18
БББББББББББББББББ
БББББББББББББББББ
Network Layer events
ББББББ
ББББББ
1b
БББББББББББББББББ
БББББББББББББББББ
SRTP Server events
ББББББ
ББББББ
1c
БББББББББББББББББ
БББББББББББББББББ
Channel API
Refer to Chapter 6, Troubleshooting, for information on interpreting the logged events.
LOGIN Command
The LOGIN command has the form:
LOGIN
The LOGIN command will be followed by a prompt of the form:
Password:
You should enter your password (which will not be echoed). If the password matches
the current password for the Modify level, you will receive a confirmation message and
you will be allowed access to the Modify commands. If the password does not match,
then an error message is displayed and the security level is not changed.
Please note that all characters which are typed after the password prompt except for the
Enter key are assumed to be part of the password. Specifically, the delete and backspace
characters do not have their usual meaning and are interpreted simply as password
characters. Passwords are limited to 8 characters and all characters after the eighth are
ignored. Unlike other inputs, the password does not need to be enclosed with double
quotes to achieve case sensitivity.
The factory default password is: system (lower case).
Note
There is a special variation of the LOGIN command that can only be
used in conjunction with the REM (remote) command to login on a
remote system. Refer to the REM command for a discussion of this
variation.