Gossen THERMAL GRAPHICS PRINTERS IPP 144 - 40 G - Manual (Page 6)

Each printer is addressable, which allows the connection of
up to 31 devices to one sender device via a data line at the
RS 485 interface, e.g. to a PLC.
4
Review of the
model types
There are two version of the printer: The Basic Version
IPP 144-40 G with the interface I and the Enhanced Version
IPP 144-40 GE with the interfaces I and II.
There are three option for the voltage supply: 12V DC (10V...19V
DC) or 24V DC (19V...36V DC) or 110V/230V AC (switch-mode
power supply: 85V...265V AC)
There are four option for the interface IIl :
RS 232 C, RS 485, ProfiBus or USB
The connector for the interface II of RS 232 C, RS 485 and
ProfiBus is a 9 pin D-Sub-socket. It is possible to change this
interface card in the factory. The interface option USB has a
special USB-B-socket. It is not possible to change this
interface card with the other cards. Special adapter cables
and converters are used in this situation.
Model
IPP 144-40 G
IPP 144-40 GE 232
IPP 144-40 GE 485
IPP 144-40 GE PB
IPP 144-40 GE USB
Supply Voltage
12V DC 24V DC 110/230V AC
12V DC 24V DC 110/230V AC
12V DC 24V DC 110/230V AC
12V DC 24V DC 110/230V AC
12V DC 24V DC 110/230V AC
Interface I
Yes
Yes
Yes
Yes
Yes