Gossen THERMAL GRAPHICS PRINTERS IPP 144 - 40 G - Manual (Page 13)

11
Installation
The IPP 144 - 40 G fits into a DIN standard panel cut out. It
is inserted into the switchboard opening from the front side
and is fixed against the switchboard rear using mounting
screws. The switchboard thickness must not exceed 12 mm.
4.1. Pin assignments
Pin
assignment
4. Connection
Connect the unit as shown in the connection diagramms.
Observe all national safety regulations, especially for the supply power
connections.
WARNING: This device must be grounded -ACHTUNG: Dieses Gerät muss geerdet werden !
IPP 144 - 40 G
Opt.: . . . . . . .
.
A l a r m
L N 1
+ -
Serien Nr.:
Serial No.:
No.de serie
Lithium battery inside ( VERSION E )
CE
IPP-AW
10 V...19 V DC; 20 VA
19 V...36 V DC; 18 VA
Interface II
Interface I
1
6
RS 232 C
RS485
Profi Bus
USB
1
Sig GND RXD (+)
5
9
RTS RTS DTR DTR TXD
CLA +5Vis GND RXD (- )
6
5
9
RTS DTR
Sig GND TXD RXD GND
85 V...265 V AC; 45...60Hz ; 15W
EN 61010 -1:2001 CAT III