Gossen THERMAL GRAPHICS PRINTERS IPP 144 - 40 G - Manual (Page 29)

27
The printed cursor to the left of the 5 indicates that
this position can be modified; in our example this is
the decimal digit of the day. The „Select“ key is
used to print the possible values successively; in
our example this is 0, 1, 2 and 3, To accept the
value press „Enter“; the cursor jumps to the next
position to the right ... etc.
Note:
Incorrect entries, e.g. day 33 of a month, will not be
accepted by the printer.
Instead, it starts over at the base value 00.
Eventually, the current date is printed.
>>> 24. 03. 04
Setting
the time The time is set like the date. After the current date has
been printed, the following line appears:
SET TIME NO ?
.
..
SET TIME 12 : 31 : 33
_2 : 31 : 00
If the time is modified, the seconds are automatically set to
zero.
If the time has been entered and „Enter“ has been pressed,
the following is displayed:
>>> 22 : 31 : 00
Hour
Minute
Second
TO STORE TIME; PLEASE PRESS „ENTER“
SET TIME AGAIN; PLEASE PRESS „SELECT“
If time has been entered correctly, press „Enter“. If the time
has been entered incorrectly, repeat the entry by pressing
„Select“.