Load software from external drive – FOCUS Enhancements FS-2 User Manual
Page 76
FS-2/2E Studio DTE Disk Recorder User Guide
56
5.
Select
YES
.
The following warning appears:
6.
Select
YES
to begin the OS upgrade.
7.
A message appears indicating the upgrade has
begun.
8.
After upgrade is complete, power cycle the FS-2/
2E, to reboot the system. The new software is now
loaded and ready to use.
2.5.12.3.2
Load Software from External Drive
Use this procedure to load new OS software into the
FS-2/2E without copying it to the internal drive.
1.
Power
OFF
the FS-2/2E.
2.
Remove the drive from the FS-2/2E.
3.
Connect the external FireWire drive with the new
OS software to the FS-2/2E via its
To HDD
1394
connector.
4.
Power
ON
the FS-2/2E.
5.
Follow steps
3
through
7
from the previous
instruction,
Copy Software to FS-2/2E Internal
Drive
.
6.
Power
OFF
the FS-2/2E, disconnect the external
FireWire drive and re-install the FS-2/2E internal
drive.
7.
Power
ON
the FS-2/2E.
This reboots the system and loads the software. It
is now ready for use.
OS UPGRADE ERROR
If the FS-2/2E cannot find the .bin the LCD screen
displays the message OS UPGRADE ERROR.
Check the connections between the computer and
the FS-2/2E and the upgrade file’s file name.
UPGRADE WILL
ERASE CURRENT
OS!!
CONTINUE?
EXIT
YES
NO