FOCUS Enhancements FS-2 - Manual (Page 31)

FS-2/2E Studio DTE Disk Recorder User Guide
11
Introduction
8. Pr Input - For connecting the Pr signal from component input sources.
Pr Output - For output of the Pr signal to component devices
9. Sync Input - For connecting the Sync signal on non sync on green
component sources.
Sync Output - For connecting the Sync signal to non sync on green
component devices.
10. Timecode Input - For connecting external analog VITC timecode
sources.
Timecode Output - For connection to external analog VITC timecode
devices.
11. Reference Video - For reference video loop through.
To use this Reference Video input, select REF VIDEO from GENLOCK in
the SETUP menu. If the loop-through jack is not connected, make sure
the output is terminated using an external 75 ohm terminator.
12. AES/EBU Digital Audio Input and Output - For connecting AES/EBU
input sources or output to AES/EBU devices.
13. Stereo Audio Monitor Output - For connection of audio monitors.
14. Balanced Analog Audio Input Channels 1 and 2 - For connecting
balanced analog audio input sources.
Balanced Analog Audio Output Channels 1 and 2 - For output to
balanced analog audio devices.
15. AC In - Use the power cord supplied to connect to the power outlet.
The power module contains a protective fuse. Refer to Replacing the
Power Module Fuse on page 15 for more information.
16. Video Monitor Output - For connection to a video monitor (composite).
Use this connection to view the On Screen Display .
17. DV I/O 1 and DV I/O 2 - For connection of DV video devices. These two
ports are used to pass through the DV signal. The FS-2/2E does not
support multiple DV inputs.
18. To HDD - For connecting external FireWire 400 disk drives to the FS-2/
2E. Use the FS-2/2E's HDD Bypass function with this port. When a
connection is made with Front Panel HDD Port Loop Through , it allows
the front panel FireWire connector to be used for connection of
external FireWire HDDs.
19. To Computer - For connecting the FS-2/2E to a computer's FireWire
400 port. It allows any disk drives connected to the FS-2/2E to mount
to the computer.
20. Ethernet 10/100 BaseT - For connecting FS-2/2E to a network or
computers for small file exchange, telnet, or web control. (The web
control functionality is only available for the FS-2E or the FS-2 with the
2.0 upgrade.)