FOCUS Enhancements FS-2 - Manual (Page 35)

FS-2/2E Studio DTE Disk Recorder User Guide
15
Introduction
1.10 Replacing the Power Module Fuse
The power module of the FS-2/2E contains a protective fuse.
To replace the fuse do the following:
1. Turn off the FS-2/2E.
2. Locate the power module on the rear of the unit. It is indicated as AC In .
3. Detach the power cord from the power module.
4. Locate the small recess on the top of the power module above the power
switch.
5. Use a small tipped standard screwdriver to pop open the fuse door.
6. Once open, slide the white fuse carrier out of the unit.
7. Replace the fuse with a 1.6 amp 250V slow blow fuse.
8. Reassemble the fuse carrier and slide it back into the unit.
9. Replace the fuse box door.
10. Re-attach the power cord.