FieldServer Metasys N2 FS-8700-19 - Manual (Page 25)

FS-8700-19_Metasys_N2 Driver Manual Page 25 of 51
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: [email protected]
Appendix C.2. Hardware connections
The FS-8917-16 pigtail cable is typically used for this port arrangement. Connection is
depicted in the following diagram.
FS-8917-16
FS-X20
SERIAL
+
-
G
ORANGE/WHITE
(RJ45-08)
BROWN
(RJ45-01)
BLUE/WHITE
(RJ45-04)
RJ45 Male Modular
Jack
1 2 3 4 5 6 7 8
RJ45 M ale M odular Jack
1 2 3 4 5 6 7 8
RJ45 Female M odular Jack
Appendix C.3. Configuration Settings
• The Port address in the Configuration needs to be set to R1 instead of P1.
• Line_Drive_On and Line_Drive_Off need to be defined in the connections section of the
configuration file. These need to be set to at least 0.001s. Refer to Sections 4.2 and 5.1
for more information.