FUJITSU ServerView Suite V6.10 - Manual (Page 15)

1.2.2 Prerequisites on connection blades
To prepare a connection blade for update via Update Manager, configure it as
follows:
1. Open the graphical user interface of the connection blade, e.g. via a
browser:
http://
2. Security > Secure Shell:
Set the following values:
Admin Mode: Enable
SSH Version 1: Disable
SSH Version 2: Enable
1.2.3 Prerequisites on systems with operating system ESXi
(flash via iRMC S3 using cURL)
Prerequisites:
l
Operating sytem version: ESXi 5.0 or later.
l
ServerView CIM Providers as of V6.00.05
To prepare a system running a VMware ESXi operating system for update via
Update Manager, configure it as follows:
1. Install the CIM Provider.
2. Make sure the system includes an iRMC S3 (with firmware as of 53A
for a TX/RXnnnS7 and firmware as of 5.26G for a BX920/924 S3).
3. Make sure that both the system and the iRMC S3 are connected to the
Network and configured.
4. Make sure ssh is enabled on the ESXi system.
ServerView Update Management 15
1.2 Prerequisites