FARGO electronic C16 - Manual (Page 74)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 65
Setting the DIP Switch Settings
The capital letter “X” indicates that the switch should be set to ON or DOWN.
SW1 SW2 SW3 SW4 Diagnostic modes
X X X X Test5x3 is a standard YMCKO test card.
X X Mag123A is a mag-only test card (records on
the Magnetic Stripe).
X The RibTest calibrates the Ribbon Color
Sensor (none or anything except Mono
Resin).
X X X The ResinTest is a premium resin test card.
X X The TestCore allows reading of the core pins.
In this mode, the Printer will beep every time
a core pin is detected in the Ribbon Roll.