FARGO electronic C16 - Manual (Page 198)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 189
Replacing the Card Feed Roller (D830058) – Left
Refer to Drawing D810025
Estimated Repair Time: 30 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Open the Upper Imaging Assembly.
3 Loosen the top two corner screws (130987) found just behind the top edge of
the Rear Cover.
4 Close the Upper Imaging Assembly.
5 Remove the screw (130987) by the Card Exit Ramp.
6 Remove the Rear Cover.
7 Remove the two screws (130971) that secure the Print Circuit Board to the two
Standoff screws (140047).
8 Remove the screws that hold the Main Board Brackets in place.
9 Use the thumb and index fingers of both hands to carefully pry the Print Circuit
Board from the Power Circuit Board.
10 Open the Upper Imaging Assembly.
11 Remove the top two corner screws (130987) found just behind the top edge of
the Front Cover.
12 Close the Upper Imaging Assembly.
13 Remove the screw (130987) by the Card Exit Ramp.
14 Remove the Front Cover
Continued on the next page