Using the dip switch (self-test) – FARGO electronic C16 User Manual
Page 73

RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
64
Using the DIP Switch (Self-test)
Step Procedure
1
Activate any of these diagnostic tests and Calibration modes. See
Running the
Self Test
in Section 2, page 63. During the activation of the Self-test, the Printer
will:
•
Detect the change to the DIP Switch Settings. See
in Section 2, page 64.
•
Operate the Printer in that selected Test or Calibration mode.
2
Return all the DIP switches back to their normal OFF position once the tests are
completed.
3
Leave the associated DIP switches activated to operate the Printer this way or
temporarily use the settings to test a particular Printer operation. (Note: When
altering a particular mode-of-operation (e.g., disabling the laminator or magnetic
verification), it will affect Printer operation while printing from a computer.)
4
When completed, turn OFF the power to the Printer to reset the operating mode
of the Printer.
•
The first illustration (below) shows all eight (8) switches in the normal OFF
position.
•
The second illustration (below) shows Switches No. 1,2 and 3 in the ON
position. (Note: The Ribbon Sensor calibration without the need of a PC).
(Note: Refer to the DIP Switch Settings table on the next page for additional
diagnostic selections.)