FARGO electronic C16 User Manual
Page 32

RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
23
Reviewing the TOP Line LCD Error/Status Messages (continued)
Message Cause
Solution
Mag Verify Error
The mag stripe was not encoded
properly.
procedure in
Section 2, page 46.
Mag Verifying
Indicates data on mag stripe is
being verified.
No action required.
Print Cover Open The Top Cover is not properly
shut.
in Section 2,
page 31.
Printer Ready
Indicates Printer is ready to
print.
No action required.
Printing
Indicates Printer is printing.
No action required.
Rib Calib Failed
The attempt at calibrating the
ribbon Sensor through the
Printer Driver has failed.
Be sure the ribbon is removed and
that the Printer's Top Cover is
closed. Try calibrating again.
Ribbon Error/Out
The print ribbon is either out or a
ribbon error has occurred.
procedure in Section 2, page 40.
Ribbon Jam/Out
The print ribbon has become
jammed in the Printer rollers, is
stuck to the surface of the card
or is out.
procedure in
Section 2, page 40.
Sensor Calibrate
Indicates the Ribbon Sensor is
calibrating.
No action required.
Wrong Ribbon
The wrong print ribbon is
installed.
Ribbon error (being displayed
incorrectly)
procedure in Section
2, page 38.