FARGO electronic C16 - Manual (Page 33)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 24
BOTH Line LCD Error/Status Messages
Message Cause Solution
CANCEL=Abort
RESUME=Continue
Appears when the Resume
button is pressed any time
while the Printer is powered
ON.
Also appears when the
Cancel button is pressed
during a print job.
Press the Resume button to return
the Printer to its Ready mode or, if
printing, to continue operation.
Press the Cancel button to abort the
current print job and completely
clear the Printer's memory.
CANCEL=Abort
RESUME=Reprint
Appears when the Cancel
button is pressed after an
error has occurred. Press the Resume button to
continue printing the current print
job where it left off, once the error is
cleared.
Press the Cancel button to abort the
current print job and completely
clear the Printer's memory.
DRAM Memory
Bad!
Service Required
The Printer's 2 MB memory
module is bad or not
installed properly. No action required.
EE Memory Error!
RESUME=Clear
Memory
Indicates problem with
permanent circuit board
memory See the Resolving the EE Memory
Error procedure in Section 7, page
206.
EE Memory Error!
RESUME=Retest
Permanent circuit board
memory is bad. See the Resolving the EE Memory
Error procedure in Section 7, page
206.
Press ON to
initialize Appears when the Cancel
(on/off) button is pressed
before a print job is sent,
when the Printer is in its
"Ready" mode. Press the Cancel (on/off) button to
restart the Printer and return it to its
Ready mode.