FARGO electronic C16 - Manual (Page 206)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 197
Technician Review – Removal and Replacement Procedure No. 2
Removing and replacing the Idler Springs on the C11 Card Printers
with the Magnetic Encoder
Step Procedure
1
Caution: Turn OFF the Printer and unplug the power cord from the
Printer.
2 Turn the Printer over after unplugging the power cord.
3 Remove the two (2) bottom access screws and cover, as shown below.
Continued on the next page