Freescale Semiconductor Target Interface MMDS0508 User Manual
Page 62
App en dix
MMDS Commands
A–62
MMDS0508 Target Interface
address range
: A range of addresses to trip the trigger. To specify a range, use
starting and ending constants, or use a starting address and a length value:
start-address
[:
mask
][..
end-address
]
or
start-address
[:
mask
][,
length
]
If you include a mask value, the system comparison involves only the address bits that
correspond to ones (1s) of the mask. If you include a length and a mask, the system
adds the length to the start address, then applies the mask to the start address and to the
sum, to obtain the end address.
,
: The comma directs the analyzer to not include an address, address range, data, data
range, or clip value in the trigger definition.
data
:
Data value that is to trip the trigger:
value[:mask]
If you include a mask value, the system comparison involves only the value bits that
correspond to ones (1s) of the mask.
data-range:
A range of data values to trip the trigger. To specify a range, use start and end values,
or use a starting value and a length:
start-value
[
:
mask
][
..
end-value
]
or
start-value
[
:
mask
][
::
length
]
If you include a mask value, the system comparison involves only the value bits that
correspond to ones (1s) of the mask. If you include a length and a mask, the system
adds the length to the start value, then applies the mask to the start value and to the
sum, to obtain the end address.
clips
A 15-bit value that defines MMDS0508 analyzer logic clip signals for the trigger,
specified as:
clips
[
:
mask
]
If you include a mask, the system comparison involves only the value bits that
correspond to ones (1s) of the mask. For example, the code 0x1F:0x1F, sets all clips
Freescale Semiconductor, Inc.
For More Information: www.freescale.com