Furuno FS-5070 - Manual (Page 68)

5. ROUTINE MESSAGE CALLING, RECEVING
5-8
* Xmitted message *
MAR-23-2006-23:01
ABLE ACKNOWLEDGEMENT
DESTINATION ID:
10M10S
PRIORITY : ROUTINE TX: 2138.0 kHz
TELEPHONE RX: 2138.0 kHz
RESEND
123456789
GO TO VIEW
2. Press the CANCEL key. You can now communicate with the party, over the
radiotelephone frequency specified or by the NBDP terminal unit.
Communicating by NBDP Terminal Unit
After acknowledging an individual call, do the following to communicate by NBDP Terminal
Unit. The control unit’s display shows “OCCUPIED” and the Tx and Rx frequencies. The
message from the other station appears on your NBDP Terminal Unit.
1. After receiving the message from other station, type your message and then transmit it.
2. Press the function key F10 (BREAK) to disconnect the line.
Sending automatic acknowledge (ACK BQ) with comply type “UNABLE”
When an individual call is received and the automatic acknowledge feature is active (AUTO
ACK) and comply type is “UNABLE,” the display shown below appears, indicating that the
auto acknowledge call (ACK BQ) with UNABLE is being sent.
Unable acknowledge
message in progress!
TIME TO GO : 6S
DSC FREQ : 12577.5 kHz
REASON: BUSY
DESTINATION ID : 121234567
PRIORITY : ROUTINE
It takes about seven seconds to transmit the call, after which the audio alarm sounds and
the following message appears.
Unable acknowledge
message transmitted.
DESTINATION ID : 121234567
PRIORITY : ROUTINE
CANCEL: STOP ALARM
1. Press the CANCEL key to silence the alarm. The following display appears.